I drive a 2014 Corvette Stingray LT1 7 speed manual with a cold air intake and dyno tune as the only performance mods thus far. In my quest to add more […]
Jeff Smith: Instead of the usual question from a reader, I thought the following scenario that a friend and I recently suffered through might be of help to car guys working […]
I have a 1969 Chevelle 396 4-speed, 3.55:1 rear ratio, F41 Chevy suspension on air shocks. When I do a burnout I have bad wheel hop. I tried letting the […]
I am looking for the right flywheel for my Gen VI 454 engine. The date code on the block is K106, and the engine casting number is 12550313. I purchased […]
I am running a ‘61 Comet wagon with Mustang II type front suspension with rack and pinion steering that has replaced the stock OE shock tower suspension and steering box. […]
In previous articles, we’ve talked about the importance of Considering Individual Timing Events When Choosing a Cam to help us determine the duration, lobe separation and advance needed. This is especially important […]
I am looking to change my stock 1970 Camaro alternator with an external regulator to a one-wire internal regulator with 150 amps to run my dual electric fans and other […]
I hope you can help me. I have a GEN IV 454 engine and I would like to install a manual transmission behind it. The late model overdrive transmissions like […]
It isn’t always obvious which camshaft we should choose for our engine build. Even when we fully understand the individual timing events and how each of them interact in a […]